Rapid Traverse Override Expansion Key Group - Siemens SINUMERIK 880 SW 6 Planning Manual

05.91
4.5

Rapid traverse override expansion key group

RAPID TRAVERSE OVERRIDE
The position of the rapid traverse override switch is indicated in the RAPID TRAVERSE OVER-
RIDE signals by the following code:
Position Code Override value
C B A
1 0 0 1
2 0 1 1
3 0 1 0
4 1 1 0
5 1 1 1
6 1 0 1
7 1 0 0
Notes:
• The percentage values given in the table are standard values which are stored as machine
data. They can be changed if required.
• The rapid traverse override switch codes can be transferred unchanged from input byte
m + 4 to the PLC/NC interface.
• Rapid traverse override replaces the axis selection switch in the rapid traverse override
key group. The other operator controls are deleted.
© Siemens AG 1991 All Rights Reserved
SINUMERIK 880 (PJ)
in %
1
10
50
100
6ZB5 410-0HE02
4 Description of Machine Control Panel Signals
4.5 Rapid traverse override expansion key group
IB m+4, bit 0 to 2
4–15