Additional Directives - DeDietrich C 330 ECO Installation, User And Service Manual

C 330 ECO - C 630 ECO
L = +
31/05/2012 - 7600532-01
R000360-A
n Reduction table
4.6.4.
4 Please refer to the manufacturer's instructions for the material in
4 Connection of the combustion gas exhaust directly to the buildings
4 Always clean the ducts thoroughly in cases where lining pipes are
4 It must be possible to inspect the flue or chimney.
4 .
4 For long, aluminium, combustion-gas exhaust pipes it is initially
C 630 ECO Chimney length in the various pressure zones
Boiler type
with a Ø of 350 mm
560
700
860
1000
1140
1300
(1) Calculated with rigid pipe and Elbow 90º and Outlet without hood (open 'free')
Pipe reductions per element used
Elbow 45°
Diameter
Pipe reduction Pipe reduction
150 mm 1,2 m
180 mm 1,4 m
200 mm 1,6 m
250 mm 2,0 m
300 mm 2,4 m
350 mm 2,8 m
400 mm 3,2 m

Additional Directives

question when installing the flue gas discharge and air supply
materials. If the flue gas discharge and air supply materials are not
installed according to the instructions (e.g. they are not leakproof,
not clamped in place etc.), this may cause hazardous situations
and/or result in bodily injury. After assembly, check at least all flue
gas and air–carrying parts for tightness.
brick chimneys or flues is forbidden for condensation reasons.
used and/or a connection of the air-supply.
necessary to consider the relatively high quantity of corrosive
products which are brought together with the condensate from the
exhaust pipe. The siphon on the equipment requires regular
cleaning or, preferably, an additional condensate collector can be
installed above the equipment.
(1)
Maximum length (L)
with a Ø of 400 mm
50 m
50 m
50 m
33 m
-
8
Elbow 90°
2,1 m
2,5 m
2,8 m
3,5 m
4,2 m
4,9 m
5,6 m
4. Installation
50 m
50 m
50 m
50 m
22 m
32 m
35