Inicontrol Control Panel - DeDietrich C 330 ECO Installation, User And Service Manual

5. Commissioning
C002366-B
0 2 4 6 8 10 12 14
LANGUE
Français - Deutsch - English -
E
1
Italiano - Espanol - Nederlands
2 - Pycck - Polski - Türk -
1
D
2
bar
# F !

% $
J I
STD
52
16 18 20 22 24
FRANCAIS
C002286-C
3. Turn on the boiler using the on/off switch.
4. The first time the boiler is powered up, the LANGUAGE menu is
displayed. Select the desired language by turning the rotary
button.
5. To confirm, press the rotary button.
Error during the start-up procedure:
4 No information is shown on the display:
- Check the mains supply voltage
- Check the fuses
- Check the connection of the power cable to the connector X1
on the PCU PCB
- Check the display flat cable
4 If there is a problem, the error is displayed on the screen.
¼ See the manual for the control panel.
5.3.2.

IniControl control panel

1. Open the main gas supply.
2. Open the gas valve on the boiler.
3. Turn on the boiler using the on/off switch.
4. Set the controls (thermostats, control system) so that they request
heat.
5. The start-up cycle begins and cannot be interrupted. During the
start-up cycle, the display shows the following information:
A short test where all segments of the display are visible.
fK[xx : Software version
pK[xx : Parameter version
The version numbers are displayed alternately.
By pressing the ® key for a short time, the current operating status
is shown on the display:
Heat demand Heat demand stopped
1 : Fan ON 5 : Burner stop
" : Boiler is igniting 6 : Post-circulation of the pump
3 : Heating System 0 : Standby
In addition to 0, in STAND-BY the display normally shows the water
pressure and the symbols d, 5 t H and r.
Error during the start-up procedure:
4 No information is shown on the display:
- Check the mains supply voltage
- Check the main fuses
C 330 ECO - C 630 ECO
31/05/2012 - 7600532-01