Connecting The Simple Logger ® Ii To A Computer; Turning The Unit On - AEMC CL601 User Manual

4.2 Connecting the Simple Logger
INSTALL DATAVIEW
Connect the Simple Logger
computer. Refer to the computer manual to locate the USB port on your
computer.
The logger can be connected to the computer during a recording session,
however, additional battery drainage will occur to support the active USB
connection.
4.3

Turning the Unit On

Turn the instrument ON by performing one of the following:
• Press and hold the PRESS button for approximately 2 seconds.
Release the button after all five LEDs light up in unison.
The unit is now in the STANDBY mode (Green LED single-blinks).
NOTE: If all LEDs light instantaneously, the instrument was in SLEEP mode.
Releasing the PRESS button will show the status.
• Connect the instrument to a USB port on your computer and establish
communication with the instrument using DataView
remain ON while a communication link with the SLII Control Panel is
active (provided sufficient battery power is available during the com-
munication session).
The instrument contains protection circuitry to prevent it from being turned
on when the battery voltage is below 1.7V.
There are two thresholds for the battery voltage:
• The first is used to indicate low battery. The low battery indicator will
blink when the battery voltage drops below 1.8V.
• The second is used to determine when to terminate recording and
turn the unit off. The shutdown threshold is when the battery voltage
drops below 1.7V.
12
Shop for AEMC products online at:
BEFORE CONNECTING TO THE COMPUTER.
®
II to a USB communication port on your
®
ShopAEMC
www.
II to a Computer
®
. The logger will
®
Simple Logger
.com 1.888.610.7664
II Model CL601
®