Maintenance; Changing The Batteries - AEMC CL601 User Manual

Use only factory specified replacement parts. AEMC
responsible for any accident, incident, or malfunction following a repair
done other than by its service center or by an approved repair center.
5.1

Changing the Batteries

NOTE: It is recommended that all data is downloaded before replacing the
batteries.
WARNING: Turn the unit off before changing the batteries or loss of recorded
data may occur. Disconnect the unit from any voltage measurement points
before opening the rear cover to change the batteries.
• Remove the screw from the battery cover
• Slide off cover to remove
• Replace with only 1.5V AA alkaline batteries, then replace cover
• Press the
NOTE: If the instrument is stored without the batteries installed, the
internal clock will need to be reset using the Simple Logger
Panel software once the batteries are installed.
Only store the unit with the batteries installed for short periods of time. For
prolonged storage of the unit, it is recommended to remove the batteries.
WARNING: Pressing the RESET button can result in the loss of recorded data.
The instrument will try to recover normally, however under certain conditions,
the clock may reset and the memory may fill. The clock may then need to
be set and memory erased before another recording can start. The RESET
button should only be pressed as a last resort.
An additional memory backup capacitor is used to provide backup power
while the main batteries are being changed. This backup power will last for
approximately 10 seconds while batteries are not installed.
Simple Logger II Model CL601
®
Shop for AEMC products online at:
CHAPTER 5

MAINTENANCE

PRESS button for 2 seconds to turn ON
ShopAEMC
www.
will not be held
®
®
.com 1.888.610.7664
II Control
19