Table of Contents
Advertisement
7.5.4 Start Energy Saver System High Alert Mode from the UPS Command Menu
To start High Alert mode:
NOTE
•
The High Alert mode commands are displayed only if enabled at the factory or by an Eaton
Customer Service Engineer.
•
The Variable Module Management System and Energy Saver System modes are mutually exclusive. If the
Variable Module Management System mode is enabled, the Energy Saver System mode commands will
not be displayed.
Press the
1.
CONTROLS
2.
On the System Status screen, select the
3.
Press the
CONTROLS
Command screen is displayed.
4.
On the UPS Control Command screen, select
5.
Press the
pushbutton on the UPS Command menu bar.
SELECT
The UPS starts High Alert mode with the UPMs online supplying the critical load. After one hour the
UPS transfers to Energy Saver System mode.
The Online status indicator is illuminated. The UPS status indicates HIGH ALERT. The UPM
status indicates ONLINE. The power module is on.
7.5.5 Enable Variable Module Management System Mode from the UPS Command Menu
To enable Variable Module Management System mode:
NOTE
•
The High Alert mode commands are displayed only if enabled at the factory or by an Eaton Customer
Service Engineer.
The Variable Module Management System and Energy Saver System modes are mutually exclusive.
•
If the Variable Module Management System mode is enabled, the Energy Saver System mode
commands will not be displayed.
1.
Press the
CONTROLS
displayed.
2.
On the System Status screen, select the
3.
Press the
CONTROLS
Command screen is displayed.
4.
On the UPS Control Command screen, select
5.
Press the
pushbutton on the UPS Command menu bar.
SELECT
The UPS transfers to Variable Module Management System mode. In approximately twenty seconds
the UPS calculates the required number of UPMs needed to support the load.
The Online status indicator is illuminated. The UPS status indicates ONLINE + VMMS. The UPM
status indicates ONLINE.
113
pushbutton on the main menu bar. The System Status screen is displayed.
UPS
pushbutton on the System Status menu bar. The UPS Control
pushbutton on the main menu bar. The System Status screen is
UPS
pushbutton on the System Status menu bar. The UPS Control
9395P 250 kVA / 275 kVA / 300 kVA
User's and Installation Guide
command.
.
START HIGH ALERT
command.
ENABLE VAR MODULE MANAGEMENT
.
Advertisement
Table of Contents
