Embedded Reset And Power Control Block Characteristics; Table 15. Embedded Reset And Power Control Block Characteristics - STMicroelectronics STM32L151CCT6 Manual

Electrical characteristics
Symbol
T Junction temperature range
J
1. When the ADC is used, refer to
2. It is recommended to power V
V can be tolerated during power-up and up to 140 mV in operation.
DDA
3. To sustain a voltage higher than VDD+0.3V, the internal pull-up/pull-down resistors must be disabled.
4. If T is lower, higher P
A D
on page 128).
5. In low-power dissipation state, T
max (see Table 72: Thermal characteristics on page
6.3.2

Embedded reset and power control block characteristics

The parameters given in the following table are derived from the tests performed under the
conditions summarized in

Table 15. Embedded reset and power control block characteristics

Symbol
V
DD
(1)
t
VDD
V
DD
(1)
T Reset temporization
RSTTEMPO
Power on/power down reset
V
POR/PDR
threshold
V Brown-out reset threshold 0
BOR0
V Brown-out reset threshold 1
BOR1
V Brown-out reset threshold 2
BOR2
58/135
Table 14. General operating conditions (continued)
Parameter
Table 56: ADC characteristics.
and V from the same source. A maximum difference of 300 mV between V
DD DDA
values are allowed as long as T
can be extended to -40°C to 105°C temperature range as long as T
A
Table
Parameter
rise time rate
fall time rate
DocID022799 Rev 10
Conditions
6 suffix version
7 suffix version
does not exceed T max (see
J J
128).
14.
Conditions
BOR detector enabled
BOR detector disabled
BOR detector enabled
BOR detector disabled
V rising, BOR enabled
DD
V rising, BOR
DD
(2)
disabled
Falling edge
Rising edge
Falling edge
Rising edge
Falling edge
Rising edge
Falling edge
Rising edge
STM32L151xC STM32L152xC
Min Max
–40 105
–40 110
DD
Table 72: Thermal characteristics
does not exceed T
J
Min Typ Max
∞
0 -
0 - 1000
∞
20 -
0 - 1000
- 2 3.3
0.4 0.7 1.6
1 1.5 1.65
1.3 1.5 1.65
1.67 1.7 1.74
1.69 1.76 1.8
1.87 1.93 1.97
1.96 2.03 2.07
2.22 2.30 2.35
2.31 2.41 2.44
Unit
°C
and
J
Unit
µs/V
ms
V