Bringing Up The Board - Motorola MVME167P Installation And Use Manual

Startup and Operation
2

Bringing up the Board

Caution
!
Caution
2-4
STARTUP
INITIALIZATION
POST
BOOTING
MONITOR
Figure 2-1. MVME167P/Firmware System Startup
This section summarizes the configuration guidelines presented in Chapter
1 and describes the process of putting the MVME167P board into service.
The MVME167P comes with MVME167Bug firmware installed. To
ensure that the firmware operates properly with the board, follow the steps
listed below.
Turn all equipment power OFF. Refer to
and verify that jumpers and switches are configured as necessary for your
particular application.
Inserting or removing boards with power applied may damage board
components.
1. Jumper header J1 on the MVME167P contains eight segments,
which all affect the operation of the firmware. They are read as a
register (at location $FFF40088) in the VMEchip2 Local
Power-up/reset initialization
Initialization of devices on the MVME167P
module/system
Power-On Self-Test diagnostics
Firmware-configured boot mechanism,
if so configured. Default is no boot.
Interactive, command-driven on-line
debugger, when terminal connected.
Preparing the Board on page 1-5
Computer Group Literature Center Web Site