Pppoe Ifadd - THOMSON SpeedTouch 608 Cli Reference Manual

pppoe ifadd

Create a new PPPoE interface.
SYNTAX:
pppoe ifadd
where:
intf
dest
EXAMPLE:
=>pppoe iflist
PPPoE1: dest : pppoe1
Retry : 10
mode = IP routing
flags = echo magic accomp restart mru addr savepwd
dns metric = 0
auth = auto user =
admin state = down
LCP : state = initial
IPCP: state = initial
acname : --- service : ---
=>pppoe ifadd intf=PPPoE2 dest=pppoe2
=>pppoe iflist
PPPoE1: dest : pppoe1
Retry : 10
mode = IP routing
flags = echo magic accomp restart mru addr savepwd
dns metric = 0
auth = auto user =
admin state = down
LCP : state = initial
IPCP: state = initial
acname : --- service : ---
PPPoE2: dest : pppoe2
Retry : 10
mode = IP routing
flags = echo magic accomp restart mru addr savepwd
dns metric = 0
auth = auto user =
admin state = down
LCP : state = initial
IPCP: state = initial
acname : --- service : ---
=>
E-DOC-CTC-20040216-0002 v1.0
[intf = <string>]
[dest = <RELAY|phonebook entry>]
The name for the new PPPoE interface.
If not specified, the destination parameter must be specified. In this case
the name of the destination will double as interface name.
The Ethernet port to be used for this PPPoE interface (e.g. an ETHoA
name).
[00:00:00]
mru = 1492
password =
oper state = down
retransm = 10
retransm = 0
[00:00:00]
mru = 1492
password =
oper state = down
retransm = 10
retransm = 0
[00:00:00]
mru = 1492
password =
oper state = down
retransm = 10
retransm = 0
link state = not-connected
term. reason =
term. reason =
link state = not-connected
term. reason =
term. reason =
link state = not-connected
term. reason =
term. reason =
PPPoE Commands
OPTIONAL
OPTIONAL
373