Nat Enable - THOMSON SpeedTouch 608 Cli Reference Manual

nat enable

Enable NAT/PAT on a SpeedTouch™ IP address.
SYNTAX:
nat enable
where:
addr
type
EXAMPLE:
=>ip aplist
1 eth0 Type:Ethernet
inet addr:10.10.10.147
UP RUNNING
IPRX bytes:19791886
IPTX bytes:839550
HWRX bytes:0
HWTX bytes:0
0 loop Type:0
inet addr:127.0.0.1
UP RUNNING
IPRX bytes:116
IPTX bytes:0
HWRX bytes:0
HWTX bytes:0
=>nat enable addr=10.10.10.147 type=pat
=>ip aplist
1 eth0 Type:Ethernet
inet addr:10.10.10.147
UP RUNNING pat
IPRX bytes:19791886
IPTX bytes:839550
HWRX bytes:0
HWTX bytes:0
0 loop Type:0
inet addr:127.0.0.1
UP RUNNING
IPRX bytes:116
IPTX bytes:0
HWRX bytes:0
HWTX bytes:0
=>
E-DOC-CTC-20040216-0002 v1.0
addr = <ip-address>
[type = <{none|pat}>]
The IP address to use for outgoing address translation. Must be one of
the own IP addresses of the SpeedTouch™.
Use the command ip aplist to obtain a list of all configured IP
Note
addresses.
Enable port translation (pat) or not (none).
HWaddr 00:80:9f:24:ab:cf
Bcast:10.10.10.255
MTU:1500 ReasmMAX:65535
unicastpkts:11341
unicastpkts:11477
unicastpkts:0
unicastpkts:0
Bcast:127.255.255.255
MTU:1500 ReasmMAX:65535
unicastpkts:0
unicastpkts:0
unicastpkts:0
unicastpkts:0
HWaddr 00:80:9f:24:ab:cf
Bcast:10.10.10.255
MTU:1500 ReasmMAX:65535
unicastpkts:11341
unicastpkts:11477
unicastpkts:0
unicastpkts:0
Bcast:127.255.255.255
MTU:1500 ReasmMAX:65535
unicastpkts:0
unicastpkts:0
unicastpkts:0
unicastpkts:0
BRHWaddr ff:ff:ff:ff:ff:ff
Mask:255.0.0.0
Group:2
brcastpkts:290555
brcastpkts:0 droppkts:0
brcastpkts:0
brcastpkts:0 droppkts:0
Mask:255.0.0.0
Group:1
brcastpkts:2
brcastpkts:0 droppkts:0
brcastpkts:0
brcastpkts:0 droppkts:0
BRHWaddr ff:ff:ff:ff:ff:ff
Mask:255.0.0.0
Group:2
brcastpkts:290555
brcastpkts:0 droppkts:0
brcastpkts:0
brcastpkts:0 droppkts:0
Mask:255.0.0.0
Group:1
brcastpkts:2
brcastpkts:0 droppkts:0
brcastpkts:0
brcastpkts:0 droppkts:0
NAT Commands
REQUIRED
OPTIONAL
339