Eth Ifconfig - THOMSON SpeedTouch 608 Cli Reference Manual

eth ifconfig

Configure the Ethernet port.
SYNTAX:
eth ifconfig
where:
intf
type
RELATED COMMANDS:
eth iflist
E-DOC-CTC-20040216-0002 v1.0
intf = <number {1-4}>
type = <{auto|10BaseTHD|10BaseTFD|100BaseTHD|100BaseTFD}
or number>
The Ethernet interface to be configured.
The Ethernet type.
Select either:
•
auto:
Auto negotiation of Ethernet communication speed (10Mb/s or
100Mb/s) and Duplex mode (half duplex or full duplex).
•
10BaseTHD:
10Mb/s communication speed in half duplex mode.
•
10BaseTFD:
10Mb/s communication speed in full duplex mode.
•
100BaseTHD:
100Mb/s communication speed in half duplex mode.
•
100BaseTFD:
100Mb/s communication speed in full duplex mode.
or enter a number between 0 (auto) and 5 (100BaseTFD).
The default is auto.
This value should never be changed, except in case of
Note
communication problems.
Show Ethernet port configuration and current operating mode.
Eth Commands
REQUIRED
REQUIRED
157