Troubleshooting - Panasonic SD-P2000 Operating Instructions Manual

Troubleshooting

When the following
conditions happen
Key operation is
disabled
Instant dry yeast
is not dispensed.
Raisins and nuts
cannot be added.
Operation stops
midway
The following sounds are normal.
Sounds are heard
during operation
and timing
Stops halfway
(Blade does not work)
＊Please consult Panasonic customer service centre.
Abnormal sounds
on the blade
Powders still
remain and
baking does not
occur
Dough is leaking
out at the
bottom of the
bread pan
The bottom of
the bread pan
turns black
Smoke or odors may occur upon initial use. However, they will disappear some time after use. Operations are not affected.
Causes
Power plug is not plug in.
Timing for automatically adding instant dry yeast depends on the room temperature
and menu you have selected.
Yeast dispenser is damp or has static electricity.
Is the instant dry yeast dampened?
Are the ingredients piled up?
Operation will be stopped if power fails for
more than 10 min.
When dough kneading and air discharge are going on,
the sounds of kneading are heard.
the sounds of motor running are heard.
When instant dry yeast and the ingredients of the raisin and nut dispenser are added
into the bread pan.
the sounds of opening the flap valve and the dispenser flap are heard.
Since too many ingredients were added or the blade is stuck on the hard ingredients,
the motor is overloaded and the protective function is hence activated, which may
cause operation to stop immediately.
(Powder still remains upon completion and baking does not happen)
There is a clearance between the blade and the shaft.
(The front end moves by 3 cm or so)
Have you forgotten to install the blade?
Is the blade shaft excessively fastened in the
bread pan so that it can't move?
A small amount of dough leaks
out from the discharge port of
( )
the bread pan during operations.
To avoid affecting the
rotations, the dough that
enters the rotational part
will be discharged.
This is normal. Please confirm
(
At the bottom of the
if the blade is rotating.
The bottom of the bread pan may turn black due to friction when kneading.
In that case, please wipe and clean with a damp kitchen towel.
Please confirm the following issues first.
If any anomaly is still identified, please
contact Panasonic customer service
centre immediately.
Plug in the power plug.
Wipe with a wrung cloth and air dry.
Use new instant dry yeast.
Spread the ingredients flat.
(P. EN18)
The dough can be used again if
the operation stops in a dough
state. (P. EN55)
Install the blade. (P. EN16)
Please replace the main shaft
bearing if the blade shaft does not
rotate.
Discharge port
( Please consult your Panasonic
(4 positions)
customer service centre
)
Shaft
bread pan
Solutions
)
EN59