Guiding Lines; Handling Of Camera - Subaru WRX-STI Owner's Manual

6-20
Interior equipment/Side View Monitor
. While the display has cooled down,
the image may leave traces or become
darker than usual, causing a difficulty
in viewing the screen. Always check
the safety around the vehicle directly
with your eyes while driving the vehi-
cle.
. The following incidents should not
be deemed a malfunction.
– The camera lens may become
foggy when the humidity is high
on a rainy day.
– The light from a vehicle or build-
ing located ahead may be reflected
towards the camera image during
driving at night.
– In a dark place or during driving
at night, the camera image may be
adjusted to make noises less visi-
ble. Therefore, the image may look
like a monochromatic image or the
image colors may differ from the
actual colors. The camera image
may be deteriorated in regard to
sharpness at the center and four
corners of the screen. This is not a
malfunction.
& Guiding lines
1) The front-of-vehicle line
2) The center-of-front-tire line
3) The side-of-vehicle line
Guiding lines that indicate the width and
the front end of the vehicle are displayed
on the monitor.
. The front-of-vehicle line:
The line shows the front part of the
vehicle.
. The center-of-front-tire line:
The line indicates the center of the front
tire.
. The side-of-vehicle line:
The line shows the vehicle width including
the outside mirrors.
NOTE
The turn signal light may overlap with
the side-of-vehicle line. This is not a
malfunction.
& Handling of camera
CAUTION
Observe the following instructions.
Otherwise, the system may malfunc-
tion.
. Do not apply any strong impact
to the camera such as banging it
or hitting it with an object. The
mounting angle may change.
. The camera unit is a waterproof
structure. Do not attempt to re-
move, disassemble or modify the
unit.
. Do not rub strongly or polish the
camera lens with a hard brush or
abrasive compounds. The lens
may be scratched resulting in an
adverse effect to the camera
image.
. The camera lens is made of glass
or plastic. Do not allow any
organic solvent, body wax, oil
film remover or glass coating
agent to become attached on