Hazard Warning Flasher - Subaru WRX-STI Owner's Manual

3-8
Instruments and controls/Hazard warning flasher
NOTE
. In CVT models, the push-button
ignition switch cannot be switched to
"OFF" when the select lever is in a
position other than "P".
. When operating the push-button
ignition switch, firmly press it all the
way.
. If the push-button ignition switch is
pressed quickly, the power may not
turn on or off.
. If the indicator light on the push-
button ignition switch flashes in green
when the push-button ignition switch is
pressed, steering is locked. When this
occurs, press the push-button ignition
switch while turning the steering wheel
left and right.
! Battery drainage prevention func-
tion
When the push-button ignition switch is
left in ON or ACC for approximately 1
hour, the push-button ignition switch will
be automatically switched to OFF to
prevent the battery from going dead. (In
CVT models, this function is activated
when the select lever is in the
position.)
& When access key does not
operate properly
Refer to Access key
not operate properly F9-17.
P

Hazard warning flasher

if access key does
The hazard warning flasher is used to
warn other drivers when you have to park
your vehicle under emergency conditions.
The hazard warning flasher works with the
ignition switch in any position.
To turn on the hazard warning flasher,
press the hazard warning button on the
instrument panel. To turn off the flasher,
press the button again.
NOTE
. When the hazard warning flasher is
on, the turn signals do not work.