Yealink SIP-T56A User Manual page 308

Smart Media Phone
User Guide for SIP-T56A
Transfer a call to the monitored user.

Pick up an incoming call of the monitored user.

Placing a Call to the Monitor User
You can tap a BLF key to dial out the monitored phone number when the monitored line is idle.
To place a call to the monitored user when the IP phone is idle:
Tap the BLF key.
1.
The IP phone dials out the phone number of the monitored user.
Transferring a Call to the Monitored User
When there is already an active call on the IP phone, you can transfer the active call to the
monitored user by tapping the BLF key. The phone handles the active call differently depending
on the configuration of the transfer mode via Dsskey with the BLF key (refer to
Transfer Mode via
Blind Transfer

Attended Transfer

New Call

To perform a blind transfer:
When the transfer mode via Dsskey is set to Blind Transfer and there is already an active call on
the IP phone, you can do the following:
Tap the BLF key of the monitored user which you want to transfer this call to.
1.
Then the active call is connected to the number of the monitored user.
To perform a semi-attended transfer:
When the transfer mode via Dsskey is set to Attended Transfer and there is already an active
call on the IP phone, you can do the following:
Tap the BLF key of the monitored user which you want to transfer this call to. The phone
1.
will dial the number of the monitored user.
Tap the BLF key of the monitored user again or the Transfer soft key to complete the
2.
transfer when receiving ringback.
To perform an attended transfer:
When the transfer mode via Dsskey is set to Attended Transfer and there is already an active
call on the IP phone, you can do the following:
Tap the BLF key of the monitored user which you want to transfer this call to. The phone
1.
will dial the number of the monitored user.
Tap the BLF key of the monitored user again or the Transfer soft key to complete the
2.
transfer after the monitored user answers the call.
308
DssKey). The transfer mode via Dsskey has the following modes:
Configuring