Yealink SIP-T56A User Manual page 282

Smart Media Phone
User Guide for SIP-T56A
If the forward on code or off code is configured, the IP phone sends the corresponding code to
the server when a certain action takes place. For example, if you set the Always Forward on code
to be *71 (may vary on different servers), and the target number to be 1234. When you enable
Always Forward on the IP phone, the IP phone sends *711234 to the server, and then the server
will enable Always Forward feature on the server side, hence being able to get the right status of
the extension.
Call forward is configurable via web user interface at the path Features->Forward & DND.
You can also enter the SIP URI or IP address in the Forward To field. For more information on
Note
using the SIP URI or IP address, refer to
Call forward is local to the phone, and may be overridden by the server settings. Call forward on
code or off code may be different among servers. For more information, contact your system
administrator.
To configure the forward authorized numbers via web user interface:
Click on Features->Forward & DND.
1.
Select Enabled from the pull-down list of Forward Emergency.
2.
Enter the numbers in the Forward Authorized Numbers field.
3.
For multiple numbers, enter a comma between every two numbers.
Click Confirm to accept the change.
4.
When call forward is enabled on the phone, the phone cannot forward incoming calls from the
numbers specified in the Forward Authorized Numbers field.
Note
Forward authorized number is configurable via web user interface only.
To disable call forward in phone mode:
Do one of the following:
- Swipe down from the top of the screen or swipe left/right to go to the second idle screen.
Tap Settings->Features->Call Forward.
Tap the desired forwarding type.
282
Placing Calls on page 252.