M3500B HeartStart XLT Defibrillator/Monitor
Monitoring
To monitor SpO
:
2
1. If the HeartStart XLT is not on, press On.
2. Apply the appropriate sensor to the patient.
3. Make sure the sensor cable is connected to the HeartStart XLT.
4. Press
to turn on SpO
A dashed line (---) is displayed under
measured and an SpO
2
displayed in place of the dashed line. As the patient's oxygen saturation
changes, the SpO
value is updated continuously.
2
Figure 5-3 SpO
Monitoring Display
2
LEAD
HR ALARM
SELECT
78
Pads
Monitoring Rhythm
ANALYZE
PAUSE
To the right of the SpO
2
played. The pleth bar should be observed for fluctuation. It is an indication of
pulsation detected by the sensor. The pleth bar should not be used as the sole
indicator of pulsation because it can be influenced by movement and artifact.
The
symbol indicates no alarm is set.
Below the SpO
value is the pulse rate derived from the pulse oximetry.
2
monitoring.
2
, while the oxygen saturation is
value is calculated. In a few seconds the SpO
SpO2
98
PR 62
Shocks: 3
00:00:49
value, a pleth bar and SpO
Monitoring
value is
2
alarm indicator are dis-
2
5
5-7