Philips HEARTSTART XLT M3500B Instructions For Use Manual page 109

M3500B HeartStart XLT Defibrillator/Monitor
Table 10-2 AED Settings:
Parameter
Defines the maximum number of shocks to
deliver before prompting
Defines the number of seconds that must pass
before the next shock is considered the first
shock of a new shock series, rather than the
next shock of the current shock series.
Initiates ECG analysis when the HeartStart
XLT is turned on in AED Mode.
Initiates ECG analysis in between shocks
within a shock series.
Monitors the ECG for potentially shockable
rhythms when the HeartStart XLT is not ana-
lyzing, defibrillating, or paused.
Defines how often (in seconds) the
itoring detects a potentially shockable rhythm.
Modifies Pause state prompts and replaces the
Pause Timer with either the Post Shock CPR
Timer or the "NSA" Timer, depending on the
event preceding the Pause state.
If is set to On, the following two configuration choices appear:
Defines the duration of the Pause time (in sec-
onds) when
since the last shock is less than or equal to the
pletion of a shock series.
Description
.
prompt is repeated when Rhythm Mon-
is pressed and the time
setting - typically at the com-
Configuring the HeartStart XLT
Setting
Choices
2, 3, 4
30, 60, 90,
120, 150, 180,
210, Off
On, Off
On, Off
On, Off
30, 45, 60, 90,
Off
Off/On
30, 60, 120,
180
10
10-11