Selecting The Lead - Philips HEARTSTART XLT M3500B Instructions For Use Manual

NOTE
M3500B HeartStart XLT Defibrillator/Monitor

Selecting the Lead

Available monitoring leads are dependent upon your device configuration:
Table 4-3 Lead Select Choices
Lead Select
Choices are:
Pads, Lead I, Lead II, Lead III
Pads, Lead I, Lead II, Lead III, aVR,
aVL, aVF, V lead.
To select a lead to monitor, cycle through the choices by pressing
the desired lead is displayed.
When V lead is selected, change to a different V lead by moving the electrode
to a new location rather than by pressing the
Figure 4-3 ECG Monitoring Display
LEAD
HR ALARM
SELECT
78
Lead II
Monitoring Rhythm
ANALYZE
PAUSE
If the desired lead is not connected or the electrodes are not making proper
contact with the patient, the message
sage Area and accompanied by a beep to alert you. A dashed line on the dis-
play indicates that there is no ECG signal.
If Configured for a:
3-lead ECG cable
5-lead ECG cable
softkey.
Shocks: 3
00:00:49
is displayed in the System Mes-
Selecting the Lead
until
4
4-5