Disabling The Hr Alarm; Adjusting The Ecg Size; Troubleshooting - Philips HEARTSTART XLT M3500B Instructions For Use Manual

M3500B HeartStart XLT Defibrillator/Monitor

Disabling the HR Alarm

If the heart rate is outside the HR alarm limits, an alarm sounds. To disable the
alarm, press .

Adjusting the ECG Size

To increase or decrease the size of the ECG, press
trol, .

Troubleshooting

Table 4-5 provides troubleshooting tips for ECG Monitoring.
Table 4-5 Troubleshooting Tips
Situation
message
or
dashed line (------)
message
appears to indicate that the alarm is disabled.
Cause
The monitoring elec-
trodes are not applied
or are not making
proper contact with the
patient.
The monitoring cable is
not connected.
The pads are not mak-
ing proper contact with
the patient.
Disabling the HR Alarm
or on the gain con-
Solution
Check that the monitoring
electrodes are properly
applied.
Check that the monitoring
cable is properly con-
nected.
Check that the pads are
properly applied.
4-7
4