Philips HEARTSTART XLT M3500B Instructions For Use Manual page 108

Configuring the HeartStart XLT
10-10
Table 10-1 General Settings (Continued)
Parameter
Captures what you just saw. All printed
strips, including those generated by an
event (mark, charge, shock or alarm),
include an additional 6 seconds of infor-
mation - the 6 seconds of information that
occurred just prior to printing being initi-
ated.
Shows pace pulse markers on the ECG
displayed, if an internal pacemaker is
detected.
Selects the monitoring electrodes source.
Defines the operating mode when the
device is turned on. Applies to a new use,
not to a continued use.
Provides an audible beep with each QRS
complex detected.
Description
Setting Up and Configuring the HeartStart XLT
Setting
Choices
6 Sec Delay /
No Delay
Leads & Pads /
Leads Only
3-lead / 5-lead
AED / Manual
Manual / AED
& Manual / Off