Decode Upc/Ean/Jan Supplementals - Motorola Symbol MS4404 Integration Manual

11 - 10 Symbol MS4404/MS4407 Integration Guide

Decode UPC/EAN/JAN Supplementals

Parameter # 10h
Supplementals are bar codes appended according to specific format conventions (e.g., UPC A+2, UPC E+2, EAN
13+2). The following options are available:
•
If you select Ignore UPC/EAN with Supplementals, and the imager is presented with a UPC/EAN plus
supplemental symbol, the imager decodes UPC/EAN and ignores the supplemental characters.
•
If you select Decode UPC/EAN with Supplementals, the imager only decodes UPC/EAN symbols with
supplemental characters, and ignores symbols without supplementals.
•
If you select Autodiscriminate UPC/EAN Supplementals, the imager decodes UPC/EAN symbols with
supplemental characters immediately. If the symbol does not have a supplemental, the imager must decode
the bar code the number of times set via
transmitting its data to confirm that there is no supplemental.
•
If you select one of the following Supplemental Mode options, the imager immediately transmits EAN-13 bar
codes starting with that prefix that have supplemental characters. If the symbol does not have a
supplemental, the imager must decode the bar code the number of times set via
Supplemental Redundancy on page 11-13
supplemental. The imager transmits UPC/EAN bar codes that do not have that prefix immediately.
• Enable 378/379 Supplemental Mode
• Enable 978/979 Supplemental Mode
NOTE If you select 978/979 Supplemental Mode and are scanning Bookland EAN bar codes, see
Enable/Disable Bookland EAN on page 11-9
ISBN Format on page
• Enable 977 Supplemental Mode
• Enable 414/419/434/439 Supplemental Mode
• Enable 491 Supplemental Mode
• Enable Smart Supplemental Mode - applies to EAN-13 bar codes starting with any prefix listed
previously.
• Supplemental User-Programmable Type 1 - applies to EAN-13 bar codes starting with a 3-digit
user-defined prefix. Set this 3-digit prefix using
• Supplemental User-Programmable Type 1 and 2 - applies to EAN-13 bar codes starting with either of
two 3-digit user-defined prefixes. Set the 3-digit prefixes using
page 11-13.
• Smart Supplemental Plus User-Programmable 1 - applies to EAN-13 bar codes starting with any prefix
listed previously or the user-defined prefix set using
• Smart Supplemental Plus User-Programmable 1 and 2 - applies to EAN-13 bar codes starting with any
prefix listed previously or one of the two user-defined prefixes set using
Supplementals on page
NOTE To minimize the risk of invalid data transmission, select either to decode or ignore supplemental
characters.
UPC/EAN/JAN Supplemental Redundancy on page 11-13
before transmitting its data to confirm that there is no
to enable Bookland EAN, and select a format using
11-20.
User-Programmable Supplementals on page
11-13.
UPC/EAN/JAN
User-Programmable Supplementals on
User-Programmable Supplementals on page
User-Programmable
before
Bookland
11-13.
11-13.