Macro Pdf Transmit / Decode Mode Symbols - Motorola Symbol MS4404 Integration Manual

Macro PDF Transmit / Decode Mode Symbols

Parameter # BCh
Select one of the options below for handling Macro PDF decoding. For Buffer All Symbols the imager can handle
sets of up to 50 maximum-sized Macro PDF symbols. In all other modes there is no limit to the size of the Macro
PDF set.
•
Buffer All Symbols / Transmit Macro PDF When Complete: This transmits all decode data from an entire
Macro PDF sequence only when the imager captures and decodes the entire sequence. Use the beeper and
LED signals when using this mode to ensure proper user feedback. If the decode data exceeds the limit of 50
symbols, there is no transmission because the entire sequence was not decoded. Use the parameter
Macro Buffer on page 11-83
•
Transmit Any Symbol in Set / No Particular Order: This transmits data from each Macro PDF symbol as
decoded, regardless of the sequence (although some error handling occurs; see
this mode, enable
to ensure proper user feedback.
•
Passthrough All Symbols: This transmits and decodes all Macro PDF symbols and performs no
processing. In this mode the host is responsible for detecting and parsing the Macro PDF sequences.
Use this mode when not using the imager's BEEPER_ON signal to drive a beeper. In the other modes, some
Macro PDF imaging sequences provide audible feedback only, so if you don't use BEEPER_ON there is no
user feedback. In
BEEPER_ON signal. By selecting Passthrough All Symbols mode, every user decode transmits to the host
where the host software can provide the appropriate feedback.
Buffer All Symbols / Transmit Macro PDF When Complete
(00h)
*
Passthrough All Symbols
(04h)
to purge the buffer.
Transmit Macro PDF Control Header on page
Table 11-6, all actions marked No Transmission provide no feedback unless you use the
11-82. Also use the beeper and LED signals
Transmit Any Symbol in Set / No Particular Order
(01h)
Symbologies 11 - 81
Flush
Table 11-6). When selecting