Led Indications - Motorola DS3407 Quick Start Manual

1
2
OPTIMUM UPRIGHT BODY POSTURE
Optimum Body Posture
for Low Scanning
DS3407
© 2012-2013 MOTOROLA, INC. All rights reserved.
Motorola reserves the right to make changes to any product to improve reliability,
function, or design. Motorola does not assume any product liability arising out of, or
in connection with, the application or use of any product, circuit, or application
described herein. No license is granted, either expressly or by implication, estoppel,
or otherwise under any patent right or patent, covering or relating to any
combination, system, apparatus, machine, material, method, or process in which
Motorola products might be used. An implied license exists only for equipment,
circuits, and subsystems contained in Motorola products.
Warranty
For the complete Motorola hardware product warranty statement, go to:
http://www.motorolasolutions.com/warranty.
For Australia Only
This warranty is given by Motorola Solutions Australia Pty Limited (ABN16 004
742 312) of Tally Ho Business Park, 10 Wesley Court. Burwood East, Victoria. Our
goods come with guarantees that cannot be excluded under the Australia
Consumer Law. You are entitled to a replacement or refund for a major failure
and compensation for any other reasonably foreseeable loss or damage. You are
also entitled to have the goods repaired or replaced if the goods fail to be of
acceptable quality and the failure does not amount to a major failure. Motorola
Solutions Australia's limited warranty above is in addition to any rights and
remedies you may have under the Australian Consumer Law. If you have any
queries, please call Motorola Solutions Australia at 1800 457 439. You may also
visit our website: http://www.motorola.com/Business/XA-EN/Pages/Contact_Us
for the most updated warranty terms.
Service Information
If you have a problem using the equipment, contact your facility's Technical or
Systems Support. If there is a problem with the equipment, they will contact the
Motorola Solutions Support Center at: http://www.motorolasolutions.com/support.
For the latest version of this guide go to: http://www.motorolasolutions.com/support.
Power Supply
Use ONLY a LISTED Motorola, Type no. 50-14000 (4.5 - 5.5Vdc/0.5A minimum), or
PWRS-14000 (4.5 - 5.5Vdc/0.5A minimum), Direct Plug-in Power Supply, marked
Class 2 or LPS (IEC60950-1, SELV). Use of alternative Power Supply will invalidate
any approvals given to this device and may be dangerous.
Motorola Solutions, Inc. One Motorola Plaza , Holtsville, New York 11742-1300, USA
http://www.motorolasolutions.com
MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M Logo are trademarks or
registered trademarks of Motorola Trademark Holding, LLC and are used under license.
All other trademarks are the property of their respective owners.
© 2013 Motorola Solutions, Inc. All rights reserved.
72-70217-01 Rev E May 2013
DS3407
Digital Scanner
3
(DS)
4
1 Tether Plate
2 LED Indicators
3 Scan Window
4 Scan Trigger
AVOID EXTREME WRIST ANGLES
OPTIMUM BODY POSTURE
AVOID BENDING
Alternate left
and right knees
AVOID REACHING
REGULATORY INFORMATION
Ergonomic Recommendations
Caution: In order to avoid or minimize the potential risk of ergonomic injury follow
the recommendations below. Consult with your local Health & Safety Manager to
ensure that you are adhering to your company's safety programs to prevent
employee injury.
• Reduce or eliminate repetitive motion
• Maintain a natural position
• Reduce or eliminate excessive force
• Keep objects that are used frequently within easy reach
• Perform tasks at correct heights
• Reduce or eliminate vibration
• Reduce or eliminate direct pressure
• Provide adjustable workstations
• Provide adequate clearance
• Provide a suitable working environment
• Improve work procedures.
Regulatory Information
This device is approved under Motorola Solutions, Inc. This device is approved
under the Symbol Technologies, Inc. brand: Symbol Technologies, Inc. is a wholly
owned subsidiary of Motorola Solutions, Inc. (collectively "Motorola").
This guide applies to Model Number: DS3400. All Motorola devices are designed
to be compliant with rules and regulations in locations they are sold and will be
labeled as required.
Local language translations are available at the following website:
http://www.motorolasolutions.com/support.
Any changes or modifications to Motorola Technologies equipment, not expressly
approved by Motorola, could void the user's authority to operate the equipment.
Antennas: Use only the supplied or an approved replacement antenna.
Unauthorized antennas, modifications, or attachments could cause damage and
may violate regulation
Radio Frequency Interference Requirements
Tested to comply
with FCC Standards
FOR HOME OR OFFICE USE
equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. However there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.
Radio Frequency Interference Requirements – Canada
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du
Canada.
Marking and European Economic Area (EEA)
Statement of Compliance
Motorola hereby declares that this device is in compliance with all the applicable
Directives, 2004/108/EC, 2006/95/EC and 2011/65/EU. A Declaration of Conformity
may be obtained from http://www.motorolasolutions.com/doc.
Ukraine
http://www.motorola.com/ds3400
OPTIMUM SCANNING POSITIONS
0 1 2 3 4 5
ALTERNATE LEFT AND RIGHT HANDS ALTERNATE LEFT AND RIGHT HANDS
TAKING BREAKS AND TASK ROTATION RECOMMENDED TAKING BREAKS AND TASK ROTATION RECOMMENDED
AVOID EXTREME
WRIST ANGLES
s.
Note: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
0 1 2 3 4 5
BEEPER INDICATIONS
Standard Use
Low/medium/high beep Short high beep
Power up Bar code decoded
[if decode beeper
enabled]
Parameter Menu Scanning
High/low/high/low beep High/low beep
Successful Correct programming
parameter sequence performed
setting

LED Indications

Off Green
Scanner is on Bar code is successfully
and ready to scan, decoded
or no power to
scanner
Optimum Body Posture for Scanning
Local Contact:
Recommended Usage Guide
C -1
Laser Devices
COMPLIES WITH 21CFR1040.10 AND 1040.11 EXCEPT FOR
DEVIATIONS PURSUANT TO
.
LASER NOTICE NO. 50, DATED JUNE 24, 2007 AND
IEC 60825-1 (Ed. 2.0), EN60825-1:2007
Class 1 Laser devices are not considered to be hazardous when used for their
intended purpose. The following statement is required to comply with US and
international regulations:
Caution: Use of controls, adjustments or performance of procedures other
than those specified herein may result in hazardous laser light exposure.
Class 2 laser scanners use a low power, visible light diode. As with any very bright
light source, such as the sun, the user should avoid staring directly into the light
beam. Momentary exposure to a Class 2 laser is not known to be harmful.
Scanner Labeling
CAUTION - CLASS 3R LASER LIGHT WHEN OPEN. AVOID DIRECT
EYE EXPOSURE LUMI»RE LASER EN CAS D'OUVERTURE DE
CLASSE 3R. EXPOSITION DANGEREUSE AU FAISCEAU. KLASSE
3R, VORSICHT - LASERLICHT, WENN ABDECKUNG GE÷FFNET.
NICHT DEM STRAHL AUSSETZEN.
LASER LIGHT- DO NOT STARE INTO BEAM . CLASS 2
LASER PRODUCT. LASERLICHT - NICHT IN DEN
STRAHL BLICKEN. LASER KLASSE 2. LUMI»RE
LASER - NE PAS REGARDER DANS LE FAISCEAU.
APPAREIL ¿ LASER DE CLASSE 2 630-680nm, 1mW
Recommended Usage Guide
4 long low beeps
Transmission error
detected; data is
ignored
Low/high beep
Incorrect
programming
sequence or
Cancel bar code
scanned
Red
Transmission
error
COMPLIES WITH 21CFR1040.10 AND 1040.11 EXCEPT FOR DEVIATIONS
PURSUANT TO LASER NOTICE NO. 50, DATED JUNE 24, 2007 AND
IEC 60825-1 (Ed. 2.0), EN60825-1:2007.
THIS CLASS B DIGITAL APPARATUS COMPLIES WITH CANADIAN
ICES-103. CET APPAREIL NUM...RIQUE DE LA CLASSE B EST
CONFORME ¿ LA NORME NMB-003 DU CANADA.