Table of Contents
Advertisement
3 SIDED LOW PROFILE FACEPLATE WITH SAFETY SCREEN INSTALLATION
Note: A mantel delector may be installed to reduce the minimum mantel height.
Refer to minimum clearances in the installation manual.
If not installing the mantel delector - proceed to step 3.
1. Line up the mantel delector (tabs to the back) with the Low Proile
backing plate.
Mantel delector
2. Bend all 3 tabs 90º to secure the delector to the top of the backing plate.
The tabs should be lush with the underside of the top lip of the back plate.
Top of backing
plate
Note: Faceplate may be installed after the unit is in its final position.
3. Install Low Proile faceplate backing plate and secure to the unit with 6
screws in locations shown below. Route power cord through the right side
of backing plate and install the grommet.
4. Install front faceplate by hooking back of front faceplate over lip edge on
unit in locations shown below. Angle faceplate slightly to hook on, lower
gently, bottom of faceplate will secure with magnets.
Power Cord
Hooks on
back of front
faceplate
Hook onto unit to install
Final Install
NOTE: To access the remote reciever pull lower portion of front
faceplate towards you. The receiver will be located on the
lower left side of the appliance.
LRI4E / HRI4E Direct Vent Gas Insert
installation
|
35
|
35
Advertisement
Table of Contents
