Regency Fireplace Products Liberty LRI4E-NG Owners & Installation Manual page 25

3. Place Log 1 on Rear Log Bracket in front of tabs, ensure Log is cen-
tered. Place small amount of glass crystals on pilot cover, over top
pilot area in front of Log 1.
Center Log 1 on bracket
4. Place Log 2 on the glass, angled with the non charred point of the Log
is approximately 9-1/4" from the right side of the burner tray.
Position Log 2
1
1
2
2
9-1/4"
5. Place Log 3, rest on Log 2, match pin locator on Log 3 with landing
pin on Log 1. Angle the longest point on Log 3 is approximately 1/4'
from the outside edge of the burner tray.
1
Line up pin locator and pin, Logs 1,3
6. Place Log 4, match pin locator on Log 4 with landing pin on Log 1.
Angle the longest point on Log 4 is approximately 1/4' from the out-
side edge of the burner tray.
4
Line up pin locator and pin, Logs 1,4
7. Place Log 5 across Log 4,match pin locator on Log 5 with landing
pin on Log 4.
Note: there are 2 pin locators on Log 5, lower locator is f o r HRI4E units
and the upper locator is for the HRI6E units.
5
Line up pin locator and pin, Logs 5,4
LRI4E / HRI4E Direct Vent Gas Insert
installation
3
2
1
3
2
1
HRI6E Pin Landing
HRI4E Pin Landing
4
|
25
| 25