installation
|
38
BACKING PLATE INSTALLATION
1. Remove Vignette faceplate from unit and lay on a soft surface.
2. Remove the outer faceplate by removing the 5 screws as shown.
Note: the two top and two bottom screws can be loosened - slide the
outer faceplate up on out to remove.
38 |
LRI4E / HRI4E Direct Vent Gas Insert
3. Attach the backing plate to the outer faceplate from the front with 7
screws (3 along the top and 2 on each side).
4. Reinstall the outer faceplate and backing plate—reverse Step 2.
tooltip
5. Reinstall the Vignette faceplate and safety screen to complete.
Final Install