Table of Contents
Advertisement
ENAMEL PANEL INSTALLATION
IMPORTANT: THIS APPLIANCE CANNOT BE OPERATED WITHOUT BRICK OR ENAMEL PANELS INSTALLED.
• Black Enamel panels must be inspected for scratches and dimples prior
to installation. All claims to be recorded at this time.
Claims for damage after installation will not receive consideration.
• Black Enamel panels will discolor a little during normal operation. This is
normal and should not be considered a defect.
All hand and inger marks MUST be cleaned off with a soft cloth. Use
*
an ammonia based cleaner (ie. glass cleaner) to remove any ingerprints
before applying heat to the unit.
Failure to do this will result in burn stains on panels which you will
be unable to remove. Not protected by product warranty.
Sheet metal components may have sharp edges. Please handle with
care. The enamel panels require an insulation panel installed behind
them. Failure to do so may result in an elevated operating temperature
and premature failure of the appliance. The Insulation panels may contain
ibre glass or ceramic elements. These may become airborne or stick to
carpets and/or clothing. Handle with caution.
The use of work gloves and dust masks is recommended when handling
panels and insulation.
Enamel panels
Panel retainers
*Insulation panels not shown in this diagram
Enamel panels
Panel retainers
*Insulation panels not shown in this diagram
Installing Enamel Panels
Before you Start:
Black Enamel Panels
HRI4E
HRI6E
1. Remove iller sections from right and left sides of the burner and discard
- see below.
2. Place the insulation panels on the inside of their respective irebox liners.
Have both the rear liner and the right liner within reach of the Firebox.
The rear liner has one long edge with perpendicular lip and one long
edge with a lip angled downward. The angled lip is the top of the panel.
The liner sits on a sheet metal ledge at the rear of the irebox, just above
the air inlet near the bottom.
While holding the rear liner in place, slide the irebox liner right (and the
corresponding insulation panel) into the right side of the Firebox. The side
liners will sit on the irebox liner retainers and it at the top in-between the
irebox side and the exhaust bafle. The rear lange on the Firebox Liner
Side, sits between the rear liner and the irebox side. When the side liner
is properly installed, the front edge should sit just inside the front edge of
the irebox.
Firebox
Liner Rear
Side and Rear Panel
Positioning
Firebox Liner Retainers
Bottom Right of Firebox
3. Install the irebox liner Left, with the corresponding Insulation Panel by
sliding it into the left side of the irebox. The rear lange of the liner must
it between the irebox liner rear and the irebox. You may have to push
the liner against the irebox as you push it rearward.
LRI4E / HRI4E Direct Vent Gas Insert
installation
|
Filler section
Interlocking of the
side and rear Firebox
Liners
Insulation Panels
Exhaust Baffle
Top Right of Firebox
31
|
31
Advertisement
Table of Contents
