Table of Contents
Advertisement
installation
|
24
HRI4E OPTIONAL LOG SET INSTALLATION
Read the instructions below carefully and refer to the images. If the logs are broken do not use the unit until they are replaced. Broken
logs can interfere with pilot operation.
Improper positioning of the logs may create carbon build-up and can alter the unit's performance which is not covered under warranty.
*For Touch Ups: Dark Brown paint is included.
Note: This Log installation is for NG units only.
1
Rear Centre Log
2
Centre Right Front Angled Log Piece
3
Right Forked Upright Log
4
Left Angled Upright Log
5
Left Angled Cross Log
6
Right Front Angled Log Piece
7
Centre Left Front Angled Log Piece
Rear Log Bracket (HRI6E/HRI4E units)
Pilot shield (HRI4E units only)
Lava Rock and Embers
Glass/Beads quantities with Log installation
HRI4E
HRI6E
Note: If glass previously installed - remove 2lbs to equal above quantity.
Ensure unit is cooled to room temperature and remove glass door.
1. HRI4E Unit only.
Remove burner (see manual for instructions).
Remove existing pilot shield by removing 2 screws.
Install pilot shield provided with Log Set using 2 screws from
previous pilot shield. Reinstall burner.
New Pilot Shield - HRI4E Only
2. Both HRI4E & HRI6E Units.
Sweep glass aside from pilot covers (if already installed) to install
Rear Log Bracket, clip the front edge of the rear bracket on to rear of
the burner as shown below.
IMPORTANT: After the Rear Log Brackets are installed glass crystals
must be reapplied. Glass crystals should not be higher then the rear log
bracket but must cover the screen portion of the pilot cover. Pilot area
needs to be clear to allow proper ignition.
24 |
LRI4E / HRI4E Direct Vent Gas Insert
OPTIONAL LOG SET INSTALLATION
6 lbs
9 lbs
5
7
4
Rear Log Brackets
NOTE: HRI4E shown above. The HRI6 pilot (not shown) is located on
the left hand side.
Reapply glass crystals to pilot cover
screen. See picture on Step 3
Rear Log Brackets
1
6
3
2
Pilot Area
Pilot Area
Advertisement
Table of Contents
