Table of Contents
Advertisement
OPTIONAL MANTEL DEFLECTOR INSTALLATION - LOW PROFILE
Low Proile Faceplate LRI4E/HRI4E Onl
Note: A mantel delector may be installed to reduce the minimum mantel
height. Refer to minimum clearances in the installation manual.
1. Line up the mantel delector (tabs to the back) with the Faceplate Back-
ing Plate.
Mantel Delector
2. Bend all 3 tabs 90º to secure the delector to the top of the backing plate.
The tabs should be lush with the underside of the top lip of the back plate.
Top of backing
plate
Note: Faceplate may be installed after the unit is in its inal position.
y
A mantel delector may be installed to reduce the minimum mantel height.
Refer to minimum clearances in the installation manual.
. Line up the mantel delector (tabs to the back) with the Outer Faceplate.
Secure in place with three screws prior to installing outer faceplate.
installation
Installed mantel delector
LRI4E / HRI4E Direct Vent Gas Insert
|
39
|
39
Advertisement
Table of Contents
