Deceleration Time - Proteco Q80A Instruction Manual

OPERATING TIME – Motor 2
Use this menu to adjust Motor 1 opening/closing.
Use only with the SEQUENTIAL Programming mode
In AUTOMATIC programming mode
1 Use
2 Press button
3 Use
4 Press button
then press button
or wait the timeout (20 seconds) to exit.
DECELERATION TIME – Motor 1
Use this setting to adjust opening/closing deceleration time for Motor 1 (from 1 to 10 seconds)
Before adjusting this setting, please make sure that parameter
= Deceleration ON
1 Use
2 Press button
3 Use
4 Press button
then press button
or wait the timeout (20 seconds) to exit.
Q80A_8_2017
PROTECO S.r.l.
Via Neive, 77 - 12050 Castagnito (CN) ITALY
working time of MOTOR 2 can't be changed.
buttons to move inside the menu, till the display shows:
to confirm.
buttons to reduce/increase Motor 2 operating time:
to go back to the top level menus,
again till the display shows:
buttons to move inside the menu, till the display shows:
to confirm.
buttons to reduce/increase Motor 1 deceleration time:
to go back to the top level menus,
again till the display shows:
Tel. +39 0173 210111 - Fax +39 0173 210199
.
in FUNCTIONS menu is:
info@proteco.net - www.proteco.net
(max)
....
(OFF)
(min)
....
(max)
26