Proteco Q80A Instruction Manual page 14

Saving a new remote control code – PEDESTRIAN START command
1 Use
Now press and hold the remote control and simultaneously press button
2
the control panel.
The display shows the radio code position.
3 If the display shows
It means that memory is full and no further code can be stored.
Repeat steps 1) and 2) to save another remote control as PEDESTRAIN START command.
4 Press button
then press button
Or wait the timeout (20 seconds) to exit.
Saving a new radio code for the 2ND RADIO CHANNEL
1 Use
2 Now press and hold the remote control and simultaneously press button
on the control panel.
The display shows the radio code position
3 If the display shows
It means that memory is full and no further code can be stored.
Repeat steps 1) and 2) to save another remote control for the 2ND RADIO CHANNEL
4 Press button
then press button
or wait the timeout (20 seconds) to exit
Deleting an existing remote control code
1 Use
2 Press button
3 Use
Press and hold button
4
5 Release button
Repeat steps 1) to 5) to delete other existing remote control codes
6 Press button
then press button
or wait the timeout (20 seconds) to exit
13
PROTECO S.r.l.
Via Neive, 77 - 12050 Castagnito (CN) ITALY
buttons to move inside the menu, till the display shows:
to go back to the top level menus,
again till the display shows:
AUX optional radio module is needed to get a 2nd Radio Channel
buttons to move inside the menu, till the display shows:
to go back to the top level menus,
again till the display shows:
buttons to move inside the menu, till the display shows:
to confirm
buttons to select the position of the code you want to delete
for about 5 seconds till the display shows
, control unit returns to stand-by
to go back to the top level menus,
again till the display shows:
Tel. +39 0173 210111 - Fax +39 0173 210199
...
.......
Q80A_8_2017
info@proteco.net - www.proteco.net
(max)
(max)