Final Release Closing; Flashing Light Mode - Proteco Q80A Instruction Manual

FINAL MOTOR RELEASE in CLOSING – Motor 1 only
Use only with the AUTOMATIC Programming mode -
This setting makes motor 1 to release the push a little bit once the gate is fully closed.
1 Use
2 Press button
3 Use
when CLOSING:
4 Press button
then press button
or wait the timeout (20 seconds) to exit.
FINAL MOTORS RELEASE in OPENING – Motor 1 and 2
Use only with the AUTOMATIC Programming mode -
This setting allows both motor to release a little bit the push once the gate is fully open.
1 Use
2 Press button
3 Use
4 Press button
then press button
or wait the timeout (20 seconds) to exit.
FLASHING LIGHT mode selection
Use this settings to select the signal mode of the falshing light according to the blinker model you have.
1 Use
2 Press button
3 Use
4 Press button
then press button
or wait the timeout (20 seconds) to exit.
23
PROTECO S.r.l.
Via Neive, 77 - 12050 Castagnito (CN) ITALY
buttons to move inside the menu, till the display shows:
to confirm.
buttons to select the level of the FINAL MOTOR 1 RELEASE
to go back to the top level menus,
again till the display shows:
buttons to move inside the menu, till the display shows:
to confirm.
buttons to select the level of the FINAL MOTORS RELEASE when OPENING:
to go back to the top level menus,
again till the display shows:
buttons to move inside the menu, till the display shows:
to confirm
buttons to select:
BLINKING signal (Standard Flashing Light)
to go back to the top level menus,
again till the display shows:
Tel. +39 0173 210111 - Fax +39 0173 210199
FIX signal (LED Flashing Light)
info@proteco.net - www.proteco.net
(OFF)
(min)
....
(max)
(OFF)
(min)
....
(max)
Q80A_8_2017