Table of Contents
Advertisement
6.
BOX Installation
Fig. 1
Fig. 2
1) Choose the place for the box and mark the fixing points on the wall.
Pay attention to respect the distances between the holes (fig. 1).
2) Make the drillings and fix the box with the pre-drilled holes downwards.
3) Slip the washer round the edge of the box, starting from centre down (fig. 2).
Do not extend the washer, just push it into its housing and cut any excess.
4) Cut the rubber grommets the same size of the wires/cables for electrical wirings (fig. 3) so that the grommet
perfectly adheres to the cable/wire. Do not cut the rubber grommets you're not going to use.
5) Put all the grommets in the pre-drilled holes of the box and drive the cables/wires (fig. 4).
6) Once wirings and installation are finished close the box and screw the cover on the box (fig. 5).
7.
DISPOSAL
Do not pollute the environment
Some electronic components may contain polluting substances.
Ensure materials are passed to the authorised collection centres, according to the laws and the regulations
on force, for safe disposal.
31
PROTECO S.r.l.
Via Neive, 77 - 12050 Castagnito (CN) ITALY
190,5
Fig. 3
Fig. 4
Fig. 5
Tel. +39 0173 210111 - Fax +39 0173 210199
Q80A_8_2017
info@proteco.net - www.proteco.net
Hide quick links:
Advertisement
Table of Contents
