Lock Pulse; Start-Up /Soft Start; Quick Closing - Proteco Q80A Instruction Manual

LOCK PULSE Function
For use with ELECTRIC-LOCK and MEL04 optional module only.
This setting makes the motors operate full power for 1 second when they are near
to closing to ensure lock returns to its striker plate.
1 Use
2 Press button
3 Use
4 Press button
then press button
or wait the timeout (20 seconds) to exit.

START-UP /SOFT START

When starting an opening cycle the control unit gives full power to both motors for 1.5 seconds in order to
overcome the gate's inertia (due to cold weather or long time inactivity).
lf SOFT START is on the control unit gives full power to the motors gradually to prevent the gate from flapping/salmming
1 Use
2 Press button
3 Use
4 Press button
then press button
or wait the timeout (20 seconds) to exit.
QUICK CLOSING Function
Quick closing after the car has gone through the photocells beam: the gate will complete opening and close
immediately after the car without waiting for the entire pause time to elapse.
If another car arrives in the meanwhile, the gate will wait the standard pause time before closing.
1 Use
2 Press button
3 Use
4 Press button
then press button
or wait the timeout (20 seconds) to exit.
21
PROTECO S.r.l.
Via Neive, 77 - 12050 Castagnito (CN) ITALY
buttons to move inside the menu, till the display shows:
to confirm.
buttons to select:
to go back to the top level menus,
again till the display shows:
buttons to move inside the menu, till the display shows:
to confirm.
buttons to select:
to go back to the top level menus,
again till the display shows:
buttons to move inside the menu, till the display shows:
to confirm.
buttons to select:
to go back to the top level menus,
again till the display shows:
Tel. +39 0173 210111 - Fax +39 0173 210199
LOCK PULSE Function OFF
LOCK PULSE Function ON
START PULSE Function OFF
START PULSE Function ON
SOFT START Function ON
QUICK CLOSING Function OFF
QUICK CLOSING Function ON
info@proteco.net - www.proteco.net
Q80A_8_2017