Programming Menu; Automatic Programming Mode, With Obstacle Detection - Proteco Q80A Instruction Manual

Deleting ALL stored radio codes
1 Use
Press and hold button
2
3 Release button
4 Press button
then press button
or wait the timeout (20 seconds) to exit
4.2

PROGRAMMING menu

Press button and use
then press button
Use buttons to scroll the lower level menu.
4.2.1 Selecting the PROGRAMMING MODE

AUTOMATIC programming mode, with OBSTACLE DETECTION

IMPORTANT:
Please check first that motors force (default setting level is 7 in a 1 to 10 range) is suitable to the leaves'
weight.
In case of very light or very heavy gates please adjust
accordingly before carry-out any programming procedure: the leave shouldn't stop if a light force
is opposed.
- If possible is better to program the control unit when motors are cold (not after repeated use)
- The gate must have opening and closing ground stops for a correct AUTOMATIC programming procedure.
1 Use
Press and hold button
2
The control panel starts the automatic programming procedure, the gate will:
• Open for 3-5 seconds (no matter if it was open, closed or mid-way)
• Stop and reverse till the fully closed position
• Perform a complete opening-closing cycle
3 Now working times, deceleration times and the level of sensibility for obstacle detection
have been automatically set.
If further adjustments of the sensibility level for obstacle detection are needed,
please refer to settings
If and
programming procedure again.
NOTE:
In AUTOMATIC programming mode C1, working times of the motors (
changed.
Q80A_8_2017
PROTECO S.r.l.
Via Neive, 77 - 12050 Castagnito (CN) ITALY
buttons to move inside the menu, till the display shows:
for about 10 seconds till the display shows
, control unit returns to stand-by
to go back to the top level menus,
again till the display shows:
to select menu
to enter the PROGRAMMING menu: display will show
buttons to move inside the menu, till the display shows:
for about 10 seconds.
and in the
settings are changed once programming is completed, you need to re-start AUTOMATIC
,
and
FORCE menu.
Tel. +39 0173 210111 - Fax +39 0173 210199
settings in FORCE menu
and settings) can't be
info@proteco.net - www.proteco.net
14