Single Leaf; Separate Push-Buttons; Motors Test - Proteco Q80A Instruction Manual

SINGLE LEAF Function
Enable this setting in case of a single-leaf swing gate.
1 Use
2 Press button
3 Use
4 Press button
then press button
or wait the timeout (20 seconds) to exit.
SEPARATE PUSH-BUTTONS Function
This allows to use to different push-buttons/controls for opening and closing.
To use this function, you need to wire:
- opening push-button/control to START terminals
- closing push-button/control to PEDESTRIAN START terminals
1 Use
2 Press button
3 Use
4 Press button
then press button
or wait the timeout (20 seconds) to exit.
MOTORS TEST Function
If this function is enabled, the control panel performs a quick start-up test
with the motors to make sure that they are in operation.
1 Use
2 Press button
3 Use
4 Press button
then press button
or wait the timeout (20 seconds) to exit.
Q80A_8_2017
PROTECO S.r.l.
Via Neive, 77 - 12050 Castagnito (CN) ITALY
buttons to move inside the menu, till the display shows:
to confirm.
buttons to select:
to go back to the top level menus,
again till the display shows:
buttons to move inside the menu, till the display shows:
to confirm.
buttons to select:
to go back to the top level menus,
again till the display shows:
buttons to move inside the menu, till the display shows:
to confirm.
buttons to select:
to go back to the top level menus,
again till the display shows:
Tel. +39 0173 210111 - Fax +39 0173 210199
SINGLE LEAF Function OFF
SINGLE LEAF Function ON
SEPARATE PUSH-BUTTONS Function OFF
SEPARATE PUSH-BUTTONS Function ON
MOTORS TEST Function OFF
MOTORS TEST Function ON
info@proteco.net - www.proteco.net
22