GRAPHTEC CE6000 SERIES Setup Manual page 16

A. Install CE6000Plus Software
If you are using the Cutting Plotter for the first time, click on
[Install CE6000Plus Software] to install the device.
This operation will install the [Cutting Plotter Controller]
and [Plotter Driver].
Note
Do not connect the accompanying USB cable yet.
Doing so may prevent the [Plotter Driver] from
being installed properly.
Refer to the procedures in this User's Manual
when connecting the USB cable.
Installing the [Cutting Plotter Controller]
1
Click on [Install CE6000Plus Software].
The [Setup] screen to setup Cutting Plotter Controller
for CE6000 will appear momentarily.
Click on [Next].
2
The [Chose Destination Location] screen will appear.
Check the installation destination folder displayed. If
there is no need to change it, click on [Next].
3
The [Select Program Folder] window will appear.
Simply click on [Next].
4
When the next screen appears, click on [Finish].
This concludes the installation of the [Cutting Plotter
Controller].
Next, install the [Plotter Driver].
Installing the [Plotter Driver]
5
After installation of the [Cutting Plotter Controller]
is complete, the [Setup] screen for the [Graphtec
CE6000Plus Driver] will appear momentarily.
When it does, click on [OK].
6
Next, check to make sure the [Cutting Plotter] is not
connected to your computer, then click on [Next].
7
Click on [Next] again.
16