Using The Lsi Logic Configuration Utility Program - IBM xSeries 445 Installation Manual
Type 8870
Hide thumbs
Also See for xSeries 445:
Table of Contents
Advertisement
Complete the following steps to start the Configuration/Setup Utility program:
1. Turn on the server and watch the monitor screen.
2. When the message Press F1 for Configuration/Setup appears, press F1.
3. Follow the instructions on the screen.
Using the LSI Logic Configuration Utility program
LSI Logic Configuration is a built-in, menu-driven configuration utility program that
you can use to:
v Set a SCSI device scan order
v View or change SCSI IDs for attached devices
v Set SCSI protocol parameters on SCSI hard disk drives
Notes:
1. The integrated SCSI controller with RAID capabilities in your server supports
2. If you install a different type of RAID adapter in your server, use the
Complete the following steps to start the LSI Logic Configuration Utility program:
1. Turn on the server.
2. When the
3. Use the arrow keys to select a controller (channel) from the list of adapters;
4. Follow the instructions on the resulting screen to change the settings of the
Note: In a 16-way configuration, some options or settings are defined through
the primary server, while others must be defined on the individual server.
Ensure that options or settings on the secondary server are correct
before creating a scalable partition.
Note: Depending on your configuration, you might experience a delay before
the Configuration/Setup menu appears.
only RAID level-1 and RAID level-1 Enhanced (RAID level-1E). Installing an
optional ServeRAID controller provides additional RAID levels. See "Using the
ServeRAID configuration programs" on page 62 for information about
configuring your server for RAID operation.
configuration method supplied with the RAID adapter to view or change SCSI
settings for attached devices.
<<<Press <CTRL><C> to start LSI Logic Configuration Utility>>>
prompt appears, press Ctrl+C.
Note: If an administrator password has been set, you are prompted to type the
password to start the LSI Logic Configuration Utility program.
then, press Enter.
selected items; then, press Enter. The Device Properties and Mirroring
Properties choices produce additional screens of parameters to review or
change.
Chapter 4. Configuring your server
61
Advertisement
Table of Contents
