Using The Lsi Logic Configuration Utility Program - IBM eServer xSeries 225 Type 8647 Installation Manual

Figure 7. Hints and tips feature

Using the LSI Logic Configuration Utility program

Use the LSI Logic Configuration Utility to:
v Perform a low-level format on a SCSI hard disk drive
v View or change SCSI IDs for attached devices
v Set SCSI protocol parameters on SCSI hard disk drives
Notes:
1. The integrated SCSI controller with RAID capabilities in your server supports
2. If your server has a RAID adapter installed, use the configuration method
Complete the following steps to start the LSI Logic Configuration Utility program:
1. Turn on the server.
2. When the prompt <<< Press <CTRL><C> to start LSI Logic Configuration
3. Use the arrow keys to select a controller (channel) from the list of adapters;
redundant array of independent disks (RAID). You can use the LSI Logic
Configuration Utility program to configure RAID level 1 for a single pair of
attached devices.
supplied with the RAID adapter to view or change SCSI settings for attached
devices.
Utility >>> appears, press Ctrl+C. If you have set an administrator password
you are prompted to type the password.
then, press Enter.
Chapter 4. Configuring your server
49