Table of Contents
Advertisement
4. Using an RXE Management cable, connect one end of the cable to the RXE
RXE Management
Figure 46. Cabling RXE Management Port - one server
5. Connect the opposite end of the cable to the RXE Management A (in) Port on
6. Connect all remaining external cables to the server; then, go to "Creating a
RXE Expansion Port cabling for two stand-alone servers: Complete the
following steps to cable two stand-alone servers to a single RXE-100 enclosure:
Figure 47. RXE Expansion cable with protective cover
44
xSeries 445 Type 8870: Installation Guide
Management Port on the server.
RXE Management Port
A (in) Port
the RXE-100 enclosure.
scalable partition" on page 63 and follow the instructions for creating a scalable
partition.
1. Determine which server will be connected to port A of the RXE-100 enclosure
and which will be connected to port B.
2. Remove the protective covers from the connectors on the ends of the cables.
Protective cover
xSeries 445
RXE-100
Advertisement
Table of Contents
