Table of Contents
Advertisement
Figure 28. Insert the serial port into PCI-X slot 1
Figure 29. Route the serial port ribbon cable through the slot
10. Go to "Installing the server in the rack cabinet" on page 33.
32
xSeries 445 Type 8870: Installation Guide
Serial port
Serial connector
5. Insert the serial port into the opening.
6. Close the tab; then, push down on the orange adapter retention latch until it
clicks into place.
Serial connector
7. Route the ribbon cable through the lower slot in the center of the server.
8. Connect the serial port ribbon cable to the connector on the center plane.
9. If you have other options to install or remove, do so now.
Tab
Adapter
retention
latch
Advertisement
Table of Contents
