Table of Contents
Advertisement
Figure 38. Routing cables through the cable management arm
c. Connect one end of a 2.5 m (8.2 ft) SMP Expansion cable to port 1 of SMP
Expansion Module 1 on the primary server; then, route the cable through the
cable-management arm as in step 3a on page 38.
d. Connect one end of a 2.5 m (8.2 ft) SMP Expansion cable to port 2 of SMP
Expansion Module 1 on the primary server; then, route the cable through the
cable-management arm as in step 3b on page 38.
e. Verify that a 25.4 cm (10 in.) SMP Expansion cable is connected between
port 3 of SMP Expansion Module 0 and port 3 of SMP Expansion Module 1.
4. Connect the SMP Expansion cables to the secondary server:
a. Locate the SMP Expansion cable that is connected to port 1 of SMP
Expansion Module 0 on the primary server; then, connect the opposite end
of the cable to port 1 of SMP Expansion Module 2. Next, route the cable
through the secondary cable-management arm.
b. Locate the SMP Expansion cable that is connected to port 2 of SMP
Expansion Module 1 on the primary server; then, connect the opposite end
of the cable to port 2 of SMP Expansion Module 2. Next, route the cable
through the secondary cable-management arm.
c. Locate the SMP Expansion cable that is connected to port 1 of SMP
Expansion Module 1 on the primary server; then, connect the opposite end
of the cable to port 1 of SMP Expansion Module 3. Next, route the cable
through the secondary cable-management arm.
d. Locate the SMP Expansion cable that is connected to port 2 of SMP
Expansion Module 0 on the primary server; then, connect the opposite end
of the cable to port 2 of SMP Expansion Module 3. Next, route the cable
through the secondary cable-management arm.
e. Verify that a 25.4 cm (10 inches) SMP Expansion cable is connected
between port 3 of SMP Expansion Module 2 and port 3 of SMP Expansion
Module 3.
Cable-management arm
Long SMP expansion cables
Chapter 2. Installing options
39
Advertisement
Table of Contents
