Table of Contents
Advertisement
Figure 24. PCI-X slot components
3. See the documentation that comes with your adapter for any cabling
4. Set any jumpers or switches as described by the adapter manufacturer.
5. Install the adapter:
28
xSeries 445 Type 8870: Installation Guide
Adapter guide
instructions.
Note: Route adapter cables before you install the adapter.
Note: Do not install an adapter in PCI-X slot 1 if you are going to install the
serial port that comes with your server. See "Installing the serial port" on
page 31 for instructions for installing the serial port.
a. Open the blue adapter guide by lifting the front edge, as shown in the
illustration.
b. Push the orange adapter retention latch toward the rear of the server and
open the tab.
c. Remove the expansion-slot cover and the PCI-X divider.
d. Carefully grasp the adapter by its top edge or upper corners, and align it
with the connector on the PCI-X board.
e. If necessary, remove the extension handles or bracket before installing a
long adapter.
Attention:
When you install an adapter, be sure the adapter is correctly
seated in the connector. Improperly seated adapters might cause damage to
the PCI-X board or to the adapter.
Tab
PCI-X
divider
Attention
LED
Power
LED
Adapter
retention
latch
Advertisement
Table of Contents
