Table of Contents
Advertisement
d. Rotate the SMP Expansion Module locking levers forward until the SMP
Expansion Module is securely fastened in place. See the following
illustration.
Center plane
Locking
levers
Figure 22. Locking lever position when the SMP Expansion Module is installed
e. Install the retention bracket.
Notes:
1. If there are two SMP Expansion Modules installed in your server, you
must install the retention bracket for each of the SMP Expansion
Modules. Be sure to install the bottom retention bracket first, then repeat
steps 2a through 2e for the top SMP Expansion Module.
2. If you are going to ship or move the server over a long distance, you
must reinstall the shipping thumbscrews.
f. Install the EMC shield. (See step 4c on page 12 if you need more detailed
information.)
Cover
Handle
Chapter 2. Installing options
25
Advertisement
Table of Contents
