Vacuum Mount Installation - Gazer F525 User Manual

Vacuum mount installation

1
Until click
Connect the frame of the device
with the mount.
360° rotation
3
You can rotate the recorder
in any direction around its axis.
Recommendation:
frame right next to the rear view mirror or behind it) in the
position in which the lens is titled slightly downward at an angle
of about 15°. If the MVR is mounted too low (on the dashboard
or a bit higher), the recorded videos will not provide full
information about the road situation because it is impossible to
see the front of your vehicle, therefore there is no «reference
point». Recordings will be significantly dimmed if the device is
mounted in parallel with the road or at an upward angle.
Install the MVR and fix the power
supply cable as shown in the drawing.
Disengaging the frame
from the mount
Press
on the tab
Disconnect
the recorder
from the mount
To remove the MVR from the mount,
follow the steps shown in the drawing.
Install your MVR as high as possible (MVR
2
ENG
4
15