Mirror installation
ENG
Back CAR SIGNAL (green)
BAT+ (yellow)
FUSE
ACC+(red)
GND (black)
DC 12V
(camera power)
Rear-view camera
VIDEO OUT
Camera
(video output)
(video input)
Fig. 3
Connect the black wire (GND) to the car chassis, the yellow BAT+ wire -
directly to the +12V terminal of the car battery or to the power line with
the constant voltage of +12V.
Connect the red wire (ACC+) to the car's +12V ACC+ power wire (ACC
power turns on when the car engine starts and turns off when it stops).
Connect the green wire (Back CAR SIGNAL) to the +12V power wire
of the rear lights. In this case, whenever the reverse gear is engaged,
the mirror will switch to the rear-view camera mode.
Connect the Camera video input jack with the rear-view camera video
output jack (VIDEO OUT). Connect the switching unit jack to the
corresponding jack on the mirror.
13