Camera Installation - Gazer CC100 User Manual

Camera installation

Installing Gazer СС100-XXX/СС100-XXX-L camera
ENG
Disconnect the AC power light plate and remove the lamp lighting.
If necessary, relocate the lamp socket and light plug connector
from the original housing to Gazer CC100-XXX camera housing.
Install the license plate light lamp into the camera housing.
Connect the license plate light power connector.
If you use Gazer CC100-XXX-L camera (with LED-based backlight),
connect the power wires of the camera lights to the power wires of
car license plate light (red wire +12V, black wire – vehicle earth).
Connect the camera to the switching and control block, as shown
on p. 9-10. Install Gazer camera instead of the license plate light
lamp.
11