Installation - Gazer H714 User Manual

Warning! Wipe the surface of the windshield before installing. Make sure
the installation place is dry and clean. Do not install the mount on 3M
scotch tape at temperature below +5°C. Because of such low
temperature and the difference between the temperature inside the car
and outdoors, the 3M scotch will lose its adhesive properties and will not
be able to fix the mount properly.
1
Prior to installing, determine the exact
MVR position on the windshield. Mark the
installation place. Remember that once
the mount is installed on the car
windshield, you cannot change the
horizontal position of the device (side to
side), only vertical position (up and down)
can be changed afterwards.
3
Remove the protective film from
3M tape.
5
By vertically turning the MVR frame point
the lens down at about 15°.
MVR installation
Make sure that the device is installed
in a position from which hit can be
conveniently removed later. Fix the
mount so that other objects do not
prevent you from monitoring status
indicators, removing the memory card
or pressing any of the buttons.
Mount the device on the car windshield.
To remove the mount from the 3M
tape on the car windshield, take a
ruler or credit card and push it gently
between the mount and the
windshield.
ENG
2
4
6
11