Vacuum Mount Installation - Gazer F122G User Manual

Vacuum mount installation

Recommendation:
sible (MVR frame right next to the rear view mirror or
behind it) in the position in which the lens is directed
slightly downward at an angle of about 15°. If the MVR
is set too low (on the dashboard or a bit higher), the
recorded videos will not provide full information about
the road situation as it is impossible to see the front of
your vehicle. Therefore, there is no «reference point».
Vacuum mount installation
Recordings will be significantly dimmed if the device is
Vacuum mount installation
set in parallel with the road or at an upward angle.
1
1
Fix the frame and the mount of
Fix the frame and the
the device on the windshield.
mount of the device on
Fix the frame and the mount of
the windshield.
the device on the windshield.
3
1
3
1
Loosen the screw 1 by turning it
counterclockwise. Adjust the MVR
position on the frame and set the
Loosen the screw 1 by
Loosen the screw 1 by turning it
recording angle. Tighten screw 1 by
counterclockwise. Adjust the MVR
turning it counterclockwise.
turning it clockwise.
position on the frame and set the
Adjust the MVR position
recording angle. Tighten screw 1 by
on the frame and set the turning it clockwise.
recording angle. Tighten
Recommendation:
frame right next to the rear view mirror or behind it) in the
screw 1 by turning it
Recommendation: position in which the lens is directed slightly downward at an
clockwise.
angle of about 15°. If the MVR is set too low (on the dashboard
frame right next to the rear view mirror or behind it) in the
or a bit higher), the recorded videos will not provide full
position in which the lens is directed slightly downward at an
information about the road situation as it is impossible to see the angle of about 15°. If the MVR is set too low (on the dashboard
front of your vehicle. Therefore, there is no «reference point».
or a bit higher), the recorded videos will not provide full
Install your MVR as high as pos-
Install the MVR and fix the power
Install the MVR and fix the
supply cable using mounting clips as
power supply cable using
shown in the drawing. Place the clips
Install the MVR and fix the power
mounting clips as shown in
evenly on the windshield to fix the
supply cable using mounting clips as
cable.
the drawing. Place the clips
shown in the drawing. Place the clips
evenly on the windshield to fix the
evenly on the windshield to
cable.
fix the cable.
2
2
To detach the MVR from the mount,
press tab 1. Then, holding the tab,
remove the recorder from the mount by
To detach the MVR from the
To detach the MVR from the mount,
sliding it to the side 2.
press tab 1. Then, holding the tab,
mount, press tab
remove the recorder from the mount by
1. Then, holding the tab,
sliding it to the side 2.
remove the recorder from
the mount by sliding it to the
Install your MVR as high as possible (MVR
side 2.
Install your MVR as high as possible (MVR
ENG
2
2
4
4
1
1
19